Moon Light Globe
Description
This is a remix of moononournation's moon model, adapted with a standard 3-1/4" collar for use with a ceiling fan or other globed light fixture. You can simply scale the entire model for other sizes. The collar has three cutouts to fit over the threads of most globed light fixtures. You can then rotate the globe 30 degrees before tightening the screws. Since this is such a long print, I recomment printing a low-quality draft-mode copy of just the collar to check the scaling and fit before printing the entire model. You may need support for the collar, but if you enable it for the entire model, your slicer may try to support every little facet of the moon, so I recommend using support blockers to limit support to the collar section only. I was able to print without any other supports just fine. I printed in Inland's "Luminous" (glow-in-the-dark) PLA.
Statistics
Likes
54
Downloads
0