Zbutt Stem Cavity Reservoir Insert
Description
This is an insert for the zbutt stem cavity to create a reservoir that contains the overflow resin that comes out of the sprue holes during casting. A resin reservoir helps to eliminate under-filling of your keycap and helps with the cleanup. Z-Butt Artisan Keycap Creation System: https://www.thingiverse.com/thing:3146222 This insert is compatible with the following zbutt stem cavity: - 1U size - 4 Sprues - No stem sprues How to use it: 1. Pour the silicone into the mold box until the silicone comes up to about 3/4th of the way up the sprues on the stem cavity. 2. Attach the insert onto the sprues and press down firmly on all 4 points to ensure that the insert is seated fully onto the sprues and is level. It should be a snug fit. 3. If needed, pour silicone around the insert until at least half the thickness of the insert is submerged in the silicone. Notes: - Print with holes side down - To remove the hardened resin from the reservoir, you will need to snip the sprues on the other side at the base of your keycap, being careful as to not damage the stem cavity mold. - There may be resin flash around the sprues, they should be thin enough to tear away from the sprues.
Statistics
Likes
25
Downloads
0