Seat Ibiza 6j air vent side piece
Description
Depending on your needs you will need to change the files before you can print them! These are files for the side piece of the air vent of a seat ibiza 6j. This is the piece that connects the two parts of the vent to make them move together. I created these using the Microsoft 3D Builder. This connecting piece itself is split in half. The half with the bigger hole in it fits the standard pins available in the air vents. The other half will fit the pin i created myself. Connect these as you need (I needed both sides to be different but you may need both sides to be the same - so just combine it the way you need it) The pin is slightly smaller than the original seat pin - you could also just make it a little larger if you needed. The pin is printable both standing upright and the other way around - the latter one turned out to give me better results. This piece is very small, so consider printing it in bulk ot together with any other print to make sure every layer has enough time to cool down to get a nice print result! Can be glued to the air vent.
Statistics
Likes
13
Downloads
0