Double Sided Filament Grabber
Description
I Made This Little 6-Inch Tool To Aid In The Pre Print Process. When Loops Of Filament Are Seeping Out Of The Extruder Before A Build, Use The Hook End (Instead Of Your Finger!) To Grab The Loose Filament Before Your Print Begins. Use The 2 Sides Of The Hex End To Clean Any Gunk Off Of The Extruder All The Way Around. This Print Only Takes About 15 Minutes! It Is A Very Handy Thing To Have Around! Warning: If You Put This Tool On The Hot End For Too Long, It Will Met Of Course!
Statistics
Likes
13
Downloads
0