Kitchen Sponge Strainer / Stand
Description
This is a Strainer/Stand for a kitchen sink sponge. Tilted at an angle, water drops coming out of the sponge will run back into the sink instead of sitting there stinking up the sponge! Parametric design. Change any parameter you want in the model. You can view it completed, and then broken down flat so you can print it easily without issue. Straight from the scad file, here's everything you can customize: // Combo is the whole model put together. // Use just_feet() and flat() for printing. // Full model put together, pretty, but not printer friendly //combo(); // PRINT THESE TWO BELOW: just_feet(); // easily printable flat(); // easily printable /////////////////////////////////////////////////////////////////// // parameters ///////////////////////////////////////////////////// /////////////////////////////////////////////////////////////////// $fn=96; // smoothness of corners, spikes, and feet //base length=115; // length in the x dimension width=69; // length in the y dimension thick=2; // height of the floor wt=4; // wall thickness wh=6; // height of the perimeter wall angle=8; // angle of base (works in conjunction with elevation) elev=6.5; // elevation of base (works in conjunction with angle) //overhang olen=106; owid=55; offset=-7.5; rounded=wt*2.12; //spikes admica=16; // distance between spikes r1=2.2; // thickness at the base r2=.5; // thickness at the point h=11; // spike height //feet fr1=.5; // bottom thickness fr2=4.5; // top thickness fh=10; // feet height
Statistics
Likes
3
Downloads
0