Anet A8 x-endstop shifter
Description
This allows the anet a8 X axis endstop to be shifted by 15mm. I designed this because after I printed [this](https://www.thingiverse.com/thing:2435075) very good BLTouch holder the carriage wasn't able to reach the sensor (It reached the acrylic frame instead). After you install it, you have to edit your config to shift X axis min position (according to your firmware) by 15mm (or less if you cannot, it will just shift all your prints and possibly reach the other end of the axis) Example for marlin: ``` // old //#define X_MIN_POS -10 // new #define X_MIN_POS 0 ```
Statistics
Likes
0
Downloads
0