Cable Wire High Strength 24lb Wall Screw Hook
Description
This wall hook boasts a 24lb weight capacity even when printed in a quality compromising position (wallhooks.stl) & 10-20% infill using PLA. Designed for a fast print & heavy load for large holes giggity the size is 1.5in (3.8cm) tall with a maximum hook opening of 1 inch (2.5cm) capable of holding even a large chain or heavy plant pot. Want to print as strong as possible? The hook was designed to print upright as well, simply use wallhooksstrong.stl instead at 100% infill. Weight limit is unknown for this version so if you find out please let me know & ill tag you right <here> with the limit you found. Hole in hook designed for #6 flat head wood screws of any length (link below). Primarily designed for extension cables, Ethernet cords, & HDMI cable etc. traversing upper corners of walls this, design has been tested thoroughly over the years to deserve it's time in the limelight. Enjoy! Consider donating, every little bit helps and motivates me to post more print worthy designs, Thank you! WARNING: DO NOT SCREW INTO WALL UNTIL TIGHT AGAINST HOOK WHEN PRINTING WITH PLA; THIS COMPROMISES AND SOMETIMES BREAKS THE SCREW HOLE. PRINT AT 100% INFILL TO AVOID THIS BUT BE AWARE HIGH PRESSURE COMPROMISES PLA. https://www.amazon.com/Snug-Fastener-Coated-Phillips-SNG3/dp/B07L49HKX2/ref=sr_1_5?dchild=1&keywords=%236+wood+screw+flat+head+phillips&qid=1599281898&sr=8-5
Statistics
Likes
5
Downloads
0