Mobula 7 Battery transverse clip => v3
Description
Hi, this is my clip to mount a 3S 300mah Lipo from side to side. Some Lipos are just a tiny bit to large to fit into the frame The clip is printed in PETG weight is below 2 gram. Infill 25% 2 wall-lines With PEtg it is flexible enough, also I use a cross at thge bottom which help that the drone stays leveled and protects the Lipo on hard landings. The clip holds the Lipo tight to the drone. I made the same for the Mobula6 for 450mah lipos. V3, has a little less weight, but no loss ins stability
Statistics
Likes
2
Downloads
0