Modular Electronics Enclosure
Description
###Overview This design is for a modular electronics enclosure for 3D printers. It utilizes a enclosure / tray system, which allows users to create a new tray if different electronics are needed. This configuration is setup to support an Mainboard (MKS Gen L, SKR 1.3, SKR 1.4, SKR 1.4 Turbo, & SKR Mini) , External Mosfet Board, and Raspberry Pi. All Hardware used in this design is M3. <hr /> ###Revisions Initial Release - September 5, 2020 Updates to design; Lid closure fasteners from one to three, added stl files for skr mini. - October 25, 2020 <hr /> ###Detailed Description This design was intended to be fully customization for other users. As it features: - Simple tray system for mounting all electronics inside the housing - Simple I/O panels which can be changed - Mounting locations for the housing on two different sides - Plastic knock-out features for cable egress The current configuration uploaded is optimized for: - MKS Gen L/SKR 1.3/SKR 1.4 - External Mosfet - Rasp Pi B+ Current Hardware Needed: - 6X - M3 Hex Nuts - 17X - M3X10mm Screws - 1X - M3X25mm Screw - 2X or 3X - M6 Screws for mounting onto your printer frame Printed BOM: - 1X - Blanking Panel 1 - 1X - Blanking Panel 2 - 5X - 1mm Spacer - 1X - Base - 2X - Hinge Pin - 1X - Electronics Chassis - 1X - Lid <hr /> ###Print Settings: Material: PETG or ABS Infill: 30% Layer Resolution: 0.2mm Support Needed: No
Statistics
Likes
12
Downloads
0