Waterpik Toothbrush Head & Flosser Stand
Description
Just a simple stand to hold a toothbrush head and flosser tip. Designed to be used with a Waterpik, but I'm sure other brands would be compatible. -Flosser shaft diameter: 7mm -Toothbrush head shaft diameter: 10mm Update 1.0: As an upgrade, adhere a foam tape of your choosing (I used a spare Command Strip and trimmed it to match the profile of the holder) to stick the holder/stand to your back splash, mirror, counter, or where ever for added stability. Update 2.0: One of my holders failed with the outside edge of the toothbrush slot breaking off. Version V2 addresses this issue by offsetting the two slots a bit to give both outside edges ~3mm of width. If you're using a stronger filament than PLA you may not have a problem here (my PolyMax PLA is holding up just fine, but the PolyLite PLA broke) and could continue to use the original version with the slots centered on the holder.
Statistics
Likes
1
Downloads
0