Ender 3 V2 Y Axis Stepper Motor Damper Mount
Description
Ender 3 V2 Y Axis Stepper Motor Damper Mount Stepper Motor Mount for the Y Axis to reduce vibrations and quiet your prints. This reuses the Ender 3 V2 Y Axis Stock Screws to mount the new motor mount. Most dampers come with M3 screws anyway. The dust cover was designed for M3s as well. Press Fit Pulley: To note, you do not have to move your pulley head on the stepper motor with this design, however, it is a little off center from original but it can be done (I did). If you have press fit pulley on your stepper you can print Press Fit Pulley Extractor / Remover which I've had a lot of success with @ https://www.thingiverse.com/thing:3593964. You can pull the pulley out a little, or replace it with a new grub screw type pulley as found on a lot of stepper motors. Print that part with Triangular Infill @ 100%. Printable Versions of Mount: Motor Mount (without Dust Cover) Motor Mount w/ Dust Cover (Dust Cover STL Included) Y Axis Sensor Mount M3 spaced or M5 spaced (Applicable to both above)
Statistics
Likes
52
Downloads
0