Raspberry Pi Zero W Clip On Case for Anycubic i3 Mega
Description
* PLEASE NOTE: This is the clip only. You will need to download one of these low profile cases: https://www.thingiverse.com/thing:1595429 This is a clip I created to attach my Raspberry Pi Zero W to the right side of my Anycubic i3 Mega-S. It works in conjunction with the low profile versions of the print-in-place case from Thingiverse user "Superrei" https://www.thingiverse.com/thing:1595429 I found this case to be quite nice, other than the fact that there was nothing to hold it closed, so it would hinge open on its own. It is for this reason that I wrapped the clip right around the case. It keeps it attached to the printer, and it keeps it closed. It fits around the section below the USB ports and above the HDMI port. Please note that the Raspberry Pi Zero/Raspberry Pi Zero W are "explicitly not recommended at all" by the creators of OctoPrint since "severe performance issues were observed caused by wifi interference when bandwidth is utilized (e.g. the webcam is streamed), negatively impacting printing quality" That said, I am not streaming from a camera, and I haven't had any problems. It's definitely slow to boot, but I just leave it on all the time. Check out my other Anycubic i3 Mega accessories! https://www.thingiverse.com/dtylerb/collections/my-anycubic-i3-mega-designs
Statistics
Likes
6
Downloads
0