Slimline FPV/Receiver Aerial Mount
Description
Hi All! Here is my slimline aerial mount. Perfect for mounting your FPV and Receiver aerial’s on to your foam board models! This has been designed for foam board model planes in mind (but will work well with other materials) to support the aerial securely (10mm flange around the outside to allow good contact with the foam board) and allows you to tilt your aerials in a sleek laid-back style. There are two versions available. The large one is for 2 aerials and the small for 1 aerial. I have not added the holes. This is so you have choice on the position and size. For a standard RP-SMA connection, you will need to drill a 6mm hole. For printing I found for best results, position the mount so the longer side of the two right angled sides towards the base (like in the photo with both mounts in them). I used a raft and supports and took approximately 55 mins to print. As always, comments and advice are welcome! Don’t forget to show your makes and show off your models! :D
Statistics
Likes
0
Downloads
0