Corona mask holder, wall mounted
Description
This is a corona virus that will hold your masks, attached to the wall. Be careful, it might try to run away with them! ;) But seriously, be careful not to mix used masks with fresh ones if you use this for storing your masks! There are two models included: my original design, solid, with an unsatisfying wall mount solution (for me). The "better" design has a huge cutout to save material (though it depends on your infill density setting) and a smarter wall mount solution. The latter may even be extended with an additional part (not designed yet). I printed my first specimen with Cura's tree supports. Two of them did were literally blown away by the hot end fan. I fixed it on the fly by replacing them with a broken print... If you are using tree support, you might want to play around with the parameters to achieve better build plate adhesion. This is a remix of greg_bejtlich's Corona Virus model. Check it out too!
Statistics
Likes
36
Downloads
0