PI1541 Case 1541-II
Description
This is actually a 90% remix of a 1541-II pi1541 case i found here, that i can't find again. I used the basemodel which was totally unprintable as it had no thickness to the walls. Several other people had commented about that, so i decided to just quickfix the model, but it soon became something else than just a quickfix. I have made several altercations and addons on it. It is made for the Ribit Version of the pi hat. I bought the hat from https://store.ribit.se/ But should work for all hats.The 0.96" oled and buttons are on the top. It is in first hand made for resin printing, and printed on my Kelant s400s using Siraya Tech Fast Grey resin without problems at 0.05 layers. It is NOT error free, but the errors does not make it unprintable. I have made testprints on my fdm also, but it does not look as good as it does in resin. I have uploaded different versions, Two for the front. One for rectangular 3mm leds, and one for 3mm round leds.Also top and bottom is 2 versions. One with a snap in one corner, and one without. The one with snap i have not printed yet. So tell me if it has problems. Buttons is printed x5. SD extension cable of 15cm is required as the slot is in the disk slot on the drive. And a piece of perfboard to relocate the IEC port to the back. It will also need a piezo disc to use sound (the one in the kit is a buzzer which does not work).
Statistics
Likes
8
Downloads
0