Remixed Boogie Board Stylus - Name and notch
Description
Designed to allow space for a string to be tied to the board, and then to the stylus (on the end of the pen). The notch lets the string be in the slot where the pen is held in the boogie board. This is the tinkercad link so you can change the name as you desire. https://www.tinkercad.com/embed/4Fdn0xYqXip?editbtn=1 Use a brim and supports to plate to ensure adhesion and that the shapes of the bottom is supported. I used pla, and printed at 0.1mm resolution so it looked smooth and the names were crisp.
Statistics
Likes
4
Downloads
0