Fish feeder with auger and hopper
Description
small fish feeder with auger system. 12volt 25 RPM gear motor $5.00 3d printed 8mm auger 3D printed hopper and lid. using shelly1 $10.00 from Shelly to control motor. auto power off setting to 3 second in Shelly timer setting. Home Assistant on a Raspberry pie4, automation script to 3 times a day+Recycled 12v 1amp power supply.. I set the infill low density used low density support for holes but next time i might try without. had to clean work hard to get supports out and clean up hole with drill. Tinkercad https://www.tinkercad.com/things/c72O4x0J2yD-fish-feeder-with-hopper updated and added enclosure. I ended up cutting off the sloped shoot on end of auger. drilled a hole for power pot between top and bottom. My facebook page with version with out 3d printed hopper and auger system. https://www.facebook.com/diyredneck/posts/175455467474422
Statistics
Likes
4
Downloads
0