Artillery Sidewinder x1 - Gantry Support Remix³
Description
This is a remix of neophrema and fdeparis modification for Artillery Sidewinder X1 printers. https://www.thingiverse.com/thing:4243350 https://www.thingiverse.com/thing:4428845 Reduces Z-wobble, reduces ghosting. With this mod there is absolutely no flex in the Z-axis anymore. See last picture, absolutely straight walls. Please consider posting a 'make' or help through commenting so we can improve this design by community efford. This design is for M10 metric rods, but if you are from US if may fit too (simply use a M10mm equivalent). Design changes: - Added center triangle-reinforcements. On the left side it will cover the 30pin ribbon cable to avoid accidental tear out. - Changed the rear bottom parts to share the case screw holes with the center triangle reinforcement. - Changed the rear bottom part to snap into the screw head of the bottom plate screw. The clamp can't move to any side anymore. - Made all parts a bit more sturdy (klingon proof), more height, width, added a stop on the top part to avoid any flex. - Changed width of the inner diameter of the top bracket and lowered height a bit to press the outer bearing tight into the blue case. Parts needed: Some original screws will fit (like the the top and bottom case screws. For the top bracket longer screws (+5mm) are needed. The bottom clamp is fixed in place with M5x40 (4x) and M5 nuts Attention: Don't overtight the M5 screw, the bottom bracket will break. Hand-tight is enough! 2x M10 rods (61-62cm) 8x M10 nuts 6x washers for M10 nuts to avoid friction on plastic parts T-nuts and countersunk screws for the triangle reinforcement
Statistics
Likes
322
Downloads
0