Split and fixed parts for For E11 Blaster
Description
As I am working on this print I find that U shape channel to be a pain, the part has been split to allow a nice smooth surface print, also saves a little time in printing, not but but it's something. just glue together on completion. Use supports where needed. This will cause a minor issue with the alignment pin, but I think the benefits outweigh that. Rear cap A and B: Included a split version of the rear cap for the NON-REMIXED barrel (this fits the outside diameter of 35mm and an inside diameter of 25.4mm pipe version) Rear cap split inner fix: This version is for those using the split pipe with the incorrect inner diameter of 22.5mm, I will also include a new front cap to match (working on it now) Front Inner fix 22.5mm: This goes with the rear cap inner fix version for those who got the 3 split pipe with the wrong inner diameter) I've also added a split version of the magwell as I had issues printing that, and it's nicer to do things with as little support as possible for nice smooth edges Wednesday, September 23, 2020 - 4:49:53 PM - added an extended muzzle end for the front, you can swap this out with the existing if you didnt glue it in in the first place (I prefer a good friction fit for some parts so I can swap or upgrade as I see fit) - This version has included bolts inside for the look. - I printed this on the bottom edge with support as the support edge goes against the barrel. Enjoy! If you enjoy my prints please consider donating, even a dollar helps :) it's always appreciated :) https://www.paypal.me/RychardK
Statistics
Likes
7
Downloads
0