Simple Folding Phone Stand
Description
Simple to print / make, this folding phone stand is great for watching films or video chats etc. It folds flat for easy transportation as is super easy to assemble. Simply print both parts on their backs (hinge parts facing upwards) without supports. Depending on your machine set up it may be required to run a 2mm drill through the hinge parts before assembly. Once printed use a length of 1.75mm filiment through the hinge and using a hot knife (or push against the hot end whilst on) to deform the ends of the filiment slightly to prevent it from dropping out. I printed mine in PETG but any material should be fine. It holds my S20 Plus in both orientations. not tested with anything bigger. Iphones should be fine also. This was designed from scratch however, the inspiration came from this very good design https://www.thingiverse.com/thing:2377538
Statistics
Likes
4
Downloads
0