Ender 5 SKR / GenL Mount
Description
I made this mount to fit a SKR V1.4 Turbo to my Ender 5. It is based on TeachingTech's [Simple Adaptor](https://www.thingiverse.com/thing:3799558) which did noch fit in my Printer, probably because Creality changed from Meanwell to Landis PSU. Besides the SKR also the MKS Gen_L and Sgen_L and any other board with similar mounting points can be used. If you use this mount, the SD Card an the USB port are no longer accessible without opening the Control Box. As i use OctoPrint, i do not feel the need to get in touch with the SD Card and I have an USB cable coming out of the hole for the display cable. Wondering why my Control Box is not between the extrusions? Check my [Ender 5 Control Box rear mount](https://www.thingiverse.com/thing:4601951) Parts needed for mounting: 3x M3 nut which should go tight into the mount 3x original board screw (those flat screws leave enough clearance for the bottom of the new board) 4x M3x10mm screws There are only 3 nuts, because one mountinghole uses a stock mountingpoint.
Statistics
Likes
10
Downloads
0