Spriya SHORT w/ box connector fitting
Description
I had to remix this to get it to work properly with the popular Bondtech E3D v6 BMG Carriage design by Richard90. After using the Triangle Labs version of his fan-mounting bracket, I had height issues with this fan duct only. Other duct's worked fine, but the Spriya fan would sit way below the nozzle even at the highest possible mounting height. My radial fan also uses a box-type fitting, so I needed to modify the duct to support that. This is the result of those changes. The distance (total height) from where the duct's fitting sits flush from the fan down to the lowest point of the fan duct (air output) is approximately 25mm. See photos for more details. This shorter length means more static pressure. So you shouldn't need to run your fan at as high of settings. If you like this design, be sure to leave a comment and a like. Thank you! "Bark bark!" RoscoeTheDog
Statistics
Likes
4
Downloads
0