Up Plus 2 E3D V6 mount
Description
E3D V6 mount for an Up Plus 2 Print settings I used: -0,1 mm layerheight (I think slightly higher won't be a problem) -60% infill -Printed in PETG but ABS, ASA or another material that is ok with high temps should be fine. Parts needed: -E3D V6 -30 x 30 fan -40 x 40 radial fan -M4 nut (mount to Up Carriage) -2 x M3 nut (V6 clamp) -4 x M2 x 5 bolt (40 x 40 fan) -4 x M3 x 12 - 15mm (30 x 30 fan) -4 x M3 x 8 (closing plate) -Bowden extruder -Bowden tube Coming update: Strain relief for the power cables and bowden tube, it is already prepared for this with holes so it shouldn't need reprinting when I add this. I'm running this on a completely modified up plus 2 with a SKR board with marlin, I don't think it's possible to get running good with the original board + firmware. If people are interested I can write a short manual on how I did this conversion with the included firmware. Also designed and lasercut an enclosure that I can share but it will take a bit of work and I feel like I'm the only person left that still uses an Up Plus so I don't want to waste my time on that. 21-10-2020: Added extruder mount
Statistics
Likes
1
Downloads
0