Anycubic Mega Pro Anti Z-wobble
Description
This is not a true remix of Thing: 3563757. Thanks Sniper_is_Silent for the cool little Z Support Mod. I've redesigned everything. The measurements were very helpful. I didn't want to remove the Z-bars for installation. That's why I used magnets. Instructions: Move the Z-axis all the way down to assemble. Then loosen the four screws on the rod on both sides ;-) , move it all the way up, and then tighten the screws again. I wish you success ! Material: 2 pieces 608ZZ ball bearings. 4 pieces 6mm neodyn magnets Additionally, I changed the clutches. I used "ruthex 3D printer coupling 5x8mm V2 [2 pieces] with 2 alignment balls".
Statistics
Likes
19
Downloads
0