Lerdge-X on Flying Bear Ghost 5
Description
Details for installing the Large-x controller in the Flying Bear Ghost5 printer. All alterations with the ability to return to the original state without traces of alteration. You don't need to drill anything. The Board and display are attached to printed adapters. All parts are printed without supports. The display panel was printed from PLA. The controller frame is made of ABS. In small holes, thread is cut for M3 screws. regular screws with washers are used to attach the main elements to the printer. To attach the Board, use screws for an imbus key or a screwdriver. Assembly of the display panel with countersunk screws. From the nuances. The motors are connected without modification. On the Ghost 5 controller, pin markings A1, A2, b1, d2 are incorrect. Limit switches: swapped pins +5V and signal (the first and third in the connectors). The controller fan is connected in parallel with the hotend fan. Left without alteration. I soldered the USB extension cable myself. The length of the wire is about 40 cm. I bought the connectors at a radio parts store. https://aliexpress.com/item/32915172172.html Base for mounting the controller Lerdge-X and Mosfet 50x60 for mostef https://aliexpress.com/item/4000287498009.html
Statistics
Likes
10
Downloads
0