Base For V.I.N.CENT
Description
Here is a simple set of stands for the VINCENT model I made ( https://www.thingiverse.com/thing:4606565 ). I haven't test printed it yet so it may or may not be bulky enough for the model, if not I will modify it, included a couple slightly different variants. one in design, one with a supported base post Print with 50% fill for the support post, Post processing will likely require a little sanding of the post at the top Tuesday, September 29, 2020 - 1:19:57 PM - added an extra 15mm to the posts as there was only just enough.
Statistics
Likes
4
Downloads
0