Nextion 5" HMI enclosure with buttons
Description
A professional industrial enclosure (HMI) for a Nextion 5" enhanced serie. The 5 buttons and 2 LEDs are connected to the GPIO pins of the Nextion display. On the side theres a micro SD Slot which is also directly connected to the display for uploading new data to the display. If you want you can install a small Emergency-Stop-Button to the top right (or just close the hole with a disc like on the photos). This HMI can be connected with a 5 pin connector to a controller (Arduino for example). This pins could be (5V, GND, Tx, Rx, Signal for EMG). If wanted you can add two o rings, one for the display, one for the backplate, to keep it more water and dust proof. Parts list: 1x Nextion 5" Enhanced Serie 5x ITW 59-111 Switch 1x Ribu Micro SD-Einbaubuchse 2x LED 103 A 3mm (Reichelt) Optional: 1x o ring 112x2mm 1x o ring 173x2mm 1x Emergency Button X6 Serie 30mm I also secured the display and the backplate with threaded insert nuts (M3) and M3 screws.
Statistics
Likes
1
Downloads
0