Anet E16 fan duct (with silicone sock)
Description
Upgraded duct for the part-cooling fan on the Anet E16, similar to my previous design but this one accommodates for the extra space needed for a silicone sock. Just like my previous one, it pretty much screws on like the original did, but replaces the nut that the factory duct uses on one of the corners with threading the screw directly into the plastic. I also included an f3d file in case you want to customize it. Make sure that the fan duct doesn’t stick out below the nozzle! If you home the z axis there should be a few millimeters between the printer bed and the fan duct. If it's too low, you can raise it a bit by tilting the hot end housing (and if you need more adjustment, you can loosen the setscrew on the heat sink and raise or lower the heat block.
Statistics
Likes
2
Downloads
0