Ultimaker 2 simple front panel
Description
Ultimaker 2 simple front panel and could be stored on the printer side Requirement: -Glue (I just used hot glue) -1.8mm acrylic or plexiglass (325mm x 315mm) Tip: Hold the acrylic panel in place with masking tape then apply glue to the brackets This design is inspired by Ultiarjan Ultimaker2 minimalist front panel https://www.thingiverse.com/thing:581159 - 325mm is the distance between the printer virtual panels - 315mm is the distance between the front panel screws to the top of the control rotation.
Statistics
Likes
0
Downloads
0