Spare Toilet Paper Roll Holder
Description
I didn't like the hole in the bottom of the holder, so I removed it in Meshmixer. That was the only change I made. I printed this pretty agressively at 0.3mm layer height and 60mm/s. I didn't have my retraction settings tuned properly for this material, so the printer left little globs of material along the edges of each band. Even though this wasn't intended, I kind of like the "fuzzy" look, so I didn't bother to reprint it. I scaled the entire print up by 5% in my slicer to accommodate the larger toilet paper rolls I use.
Statistics
Likes
7
Downloads
0