Case for FrSky G-RX6 receiver
Description
A quick-to-print case for the FrSky G-RX6. Provides proper protection. The signal pins for CH's 1 & 6 are marked with a small dot. Instructions: 1. Print the two parts of the case 2. Remove card wrapper from receiver, cut a piece 21 x 18 mm - this will be the new bed 3. Save the piece of foam under the pressure sensor. 4. Place the card from step 2 into the base, then the board, then the foam 5. Secure the two parts of the case with tape or cyano 6. Apply hot glue to the antenna exits Done! See also my [case for the RX6R](https://www.thingiverse.com/thing:3301838)
Statistics
Likes
5
Downloads
0