Ender 5 - X Stepper Cable Support
Description
This part is used to support the X stepper cable and X limit switch cable. The stepper cable does not have any support and hangs freely from the connector. This should reduce the stepper motor cable connection from taking strain while printing.  When printing, I recommend placing the support bracket as follows:  Once printed, the bracket is designed to slide on from the right to the left, the little hook should go around the QR Code plastic case as shown below:  By design it should sit quite snug and the holes to fit a M2 nut and bolt might not be required. A cable tie can also be used here if required. The cable support does not weight much (8g) and shouldn't influence the movement of the X and Y carriage.
Statistics
Likes
6
Downloads
0