VITTSJÖ Extendö II
Description
Extension for VITTSJÖ laptop stand. I designed this to raise the height of the table about 2 inches as it was not clearing the chair arms on our furniture. May work with other pieces in the VITTSJÖ series like the laptop table or nesting tables/shelves, but I'm not sure off hand. VITTSJÖ Extendö II M5.stl - M5 Nut version VITTSJÖ Extendö II.stl - Non-Metric fastener version. You will want to print 4 of these, and you will need 8 x M5 16MM and 8 x M5 Nut to fasten the leg part to the piece. Ikea's M5 screws will fit from the reverse intended direction in the counter sunk holes. This should work at either top or bottom end of the stand. I haven't tested the M5 hardware as it's harder for me to get, but will try to update if I find a problem.
Statistics
Likes
5
Downloads
0