Enclosure for Itsy 32U4 / ItsyLight
Description
Simple enclosure design for using an Adafruit ItsyBitsy 32U4 5V as the LED driver for an ambilight setup. Designed for an ambilight/adalight connected using left side ground and pins 11 and 13 for data and clock. Lid is sized to fit without much give but without being a press fit; if you need press fit, F3D file is included and pushing the inners of the lid out ~.05-.1 should give you a press fit. Printed in PLA, 2 perimeters, 2 bottom/top shells, .24 layer height; infill basically doesn't matter because there's almost no infill zones.
Statistics
Likes
2
Downloads
0