Cap for Rollei 35 S/SE
Description
Lens Cap for Rollei 35S and Rollei 35SE I was frustrated with the factory cap always falling off. This cap snaps into the filter threads and fits firmly. It will not shake off leaving your lens unprotected! There are two versions of my cap, one with a marking to show the model designations for which the cap is intended, and one unmarked. Cap will only fit Rollei 35 models with the Sonnar lens. Cap will NOT fit Rollei 35 models with a Tessar or Triotar lenses (e.g. Rollei 35T, Rollei 35TE or Rollei B35, Rollei C35 or Rollei 35LED). In principle it could fit these Tessar and Triotar models if scaled to 0.78X, but I have not tried that myself as I have no such lens for comparison. Make sure you print "flat side down" so the printing is facing the bed. That way you should not need supports. If you print flat side up, support will be required.
Statistics
Likes
7
Downloads
0