Raspberry Pi, Relays and RS-15-5 mount for Ender 5
Description
Remixed to fit 2 Relays and a MeanWell RS-15-5 on it. MW RS-15-5 to run the raspberry pi (octoprint) while printer is turned off. Relays to turn on/off the printer and LEDs individually. Wanted to keep that whole thing modular, so I decided to make adapters and use the original cables without having to cut them. Used a duo relay board to turn on/off the 230V going to the printer's power supply and the 24V coming from the printer psu powering my LEDs. Relays are made for 10A 250V AC / 10A 30V DC - so everything is safe for my usage. MW RS-15-5 is taped to the base with 3M 9088 and it really does the job! I haven't had any cooling problems so far and the 3A seems to be perfectly sufficient for the Raspberry. Only the WLan from the Raspberry is hardly usable anymore, so I laid a short patch cable with a RJ45 f/f adapter outside. Had to split the board into two parts, made the cut edge at a 45 ° angle and glued both halves together with plastic glue. Since the relays arn't too heavy, it seems to hold up quite well so far.
Statistics
Likes
13
Downloads
0