Robox DIY Smoke Alarm Power Switch using Arduino Micro
Description
What Is The Smoke Alarm Power Switch Diy For The Robox 3D Printer? A 3D Printer Smoke Alarm That Can Switch Off The 3D Printer'S Power Supply Similar To This Kickstarter Project: Https://Www.Kickstarter.Com/Projects/1064868871/Smoke-Signal-A-Safety-System-For-3D-Printers Please Support Andrew Maurer As Well (I Have No Affiliation With Him). I'M Planning To Buy His Product When It Gets Out But In The Mean Time I Started This Project Until It Becomes Available. ** Update: ** I Printed The Guard Rail And The Rj45 Clip On Am 1,01 And They All Still Fit Together. **Note: ** Please Print At 102% On The Robox 3D Printer. All Prints Were On Draft, 99% Fill And With Brim 3. Try Not To Use Brim On The Arduinomicromount. Bridging On Arduinomicromount May Fail But Let It Finish. Just Clean The Bridging Problems With A Knife Tool After. Pictures Were Printed With Am 1.00.17.
Statistics
Likes
15
Downloads
0