Gerber Multi-Plier 600 Holster
Description
Original did not fit for some reason. Way too small. I rebuilt and remodelled it from the ground up, and I rounded some edges and made a small shield so the needlenose doesn't damage your pants. 24 Nov 20: Removed "shield" version. Rebuilt files in OnShape. TIP: Print 20C higher than you normally would to ensure maximum layer adhesion. 02 Nov 20: Added a new version that is closed at the bottom. I found when I would sit down in my car it would pop out of the holster. So there are now three versions: Closed (preferred by me), Shield (original), and Minimal (which is just enough to hold it on a belt, but could be pushed out from the bottom). So far this has withstood a busy day round the house, including playing tag all afternoon with my kids outside. Lots of running, crawling, and rolling in the woods! Never fell out once. Use a brim if you have problems with adhesion. Check out my [bed levelling](https://old.reddit.com/r/ender3/comments/ewquzr/guide_how_to_level_your_bed/) guide to help to NOT have problems with adhesion!
Statistics
Likes
12
Downloads
0