Push-on Filament Guide for CR-6 SE (2.0)
Description
This is designed to be used with a top-mounted spool holder, such as that from the Ender 3. You can get all the necessary Bowden parts here (non-affiliate link) https://www.amazon.com/gp/product/B07PV9LCLY And I used this to connect to the filament out sensor - https://www.thingiverse.com/thing:4617010 This is my original design that snaps into place and is smaller - https://www.thingiverse.com/thing:4630555 I printed at 20% infill, but turned the wall line count up to 4 so that the arms would be essentially 100% infill for strength. Thanks for checking it out!
Statistics
Likes
74
Downloads
0