Dana R and Dana RS Case
Description
This is a hard case for the dana r and dana rs. The cases that came with the pump were bad so I designed a better one. This is much slimmer than the other cases. This is a friction fit, and has a hole in the bottom for pushing it out. There are 3 options. Normal one. One with a clip for clipping on shorts or shirt when changing etc. One with a loop which can either be put on your belt or put on some elastic and worn on the arm. These should be printed standing up, and only the clip one needs supports touching build plate. This pump should sit snugly in the case, if it doesn't alter the slicer settings to increase or decrease the thickness. The fit will be different if you have stickers on the pump. Could also print in TPU or some flexible for a soft case, but I have not tried this. Good luck. #Wearenotwaiting
Statistics
Likes
5
Downloads
0