Car Tube Storage
Description
Not the most exciting print (and it does use a little bit of filament) but I was on a functional print kick and thought Id use up some filament that had been sitting for a bit long AND tidy up the back of the car. Just big enough for shoving a few safety vests so they can be out of the way what is the good idea here is I added some Hook (Velcro Hook and Loop) to the bottom and one side of the holder so it can sit in the boot of the car and not slide around. I printed this in PLA which means it will probably warp somewhat in the car if it gets too hot so you might want to think about that if that is a problem, but its only for simple storage so a little warping is probably ok. You can check it on the print but its about 153mm tall (just tall enough for safety vests and to fit in the spot I wanted in the car) with each tube having a 110mm diameter
Statistics
Likes
1
Downloads
0