Iron Man MK46 Helmet Motorization
Description
***Update 1/2/2021 - Added Link to "Frankly Built's" YouTube video showing the installation of the kit.*** ***Update 11/16/20 - Also available for purchase is an easy to install and use Arduino shield (Nano included) designed specifically for this project. This Board comes pre-flashed with the Crashworks code installed.*** A.L.I.S.H.A.(MK2, MK5, and MK6), S.U.E. (Sound Unit Expansion), PENELOPE (USB Power Keep Alive Board) ***https://www.ebay.com/itm/403228425344*** ------------------------------------------------------------------------------------------------------------------------ ***Link to our MK7 Helmet motorization kit: https://www.thingiverse.com/thing:4630066*** ***Link to our MK85 Helmet motorization kit: https://www.thingiverse.com/thing:4607836*** ***Link to our Marvel Legends Helmet motorization kit: https://www.thingiverse.com/thing:5175364*** ------------------------------------------------------------------------------------------------------------------------ ***This is a complete motorization kit for the MK46 helmets, and should work with most of the current MK46 designs.*** ***Use this link to download the required Arduino code for this project: https://github.com/crashworks3d/Iron_Man_Servo*** ***As the Arduino code is constantly evolving, if your code exhibits any unusual behavior please check the GitHub link to ensure you have the most current version of the Iron_Man_Servo Code*** ***Please read attached MK46 Helmet Tutorial, it lists all the steps necessary for this project*** ***You will need metric size screws for this project, the most common sizes are M3 & M4. As an example they are normally labeled as follows M3-0.5 which means M3 (Diameter / Size) -0.5(Thread Pitch), or M4-0.7 which means M4 (Diameter / Size) -0.7(Thread Pitch).*** Included are all of the files needed to fit and align servos into your helmet. Servo mounts for both the Tower Pro MG90s and clone Non-Tower Pro MG90s servos are included. Included files: ***MK46 Helmet Tutorial*** MK46 Servo Mount (Tower Pro MG90s) MK46 Servo Mount (Non-Tower Pro MG90s) Servo Mount Wire Cover Servo Horn Arm Geared 4mm Hole (60mm) Faceplate Bracket Rounded 4mm Hole (MK7 74.5mm) Cotter Pin 3.6D (15mm) Helper Arm Helper Arm Mount Short (M4) Helper Arm Mount Tall (M4) Servo Alignment Tool (Adjustable) Part A Servo Alignment Tool (Adjustable) Part B Helper Arm Tool (A) Helper Arm Tool (B) ***Do not scale any of the files, as they are all size specific*** ***Print the following files:*** 1x Tower Pro servo mount -OR- 1x Clone Tower Pro servo mount 2x Servo Horn Arm Geared 4mm Hole (60mm) 1x Faceplate Bracket Rounded 4mm Hole (74.5mm) 2x Cotter Pin 3.6D (15mm) 2x Helper arm 4x Helper Arm Mount Short (M4) - OR- 4x Helper Arm Mount Tall (M4) 1x Servo Alignment Tool (Adjustable) Part A 1x Servo Alignment Tool (Adjustable) Part B 1x Helper Arm Tool(A) 1x Helper Arm Tool(B) 1x Servo Mount Wire Cover
Statistics
Likes
91
Downloads
0