HYPR Hot Swap Afterburner
Description
I am going to post new makes on my prusa account, thingiverse is making it too hard to upload here. https://www.prusaprinters.org/social/114667-racerethan/prints Hot swap afterburner for the HYPR, in similar fashion to my WSPR hot swap afterburner Wiring diagram is similar to a stryfe. Can also use a stryfe motor braking wiring diagram to make reloading faster. Micro switch is just glued on the side like the photo. Battery is just held in by rubber bands. The flywheel set up in the picture is 2 CC wheels and 2 OOD valkyries. Hardware- 2 motors 2 flywheels. Cage is a 43.5 dominator base. Use lower crush wheels so you can stick darts through the flywheels. 2 10-32 caliburn screws 3 10-32 nuts lever micro switch 4.2 inch .527 caliburn barrel for the main barrel and a 1.2 inch 5/8 od barrel for the flywheel holder. 18g or lower silicone wire. 6-32 screw for battery mount heat shrink whatever battery to go with the motors and connectors for it. superglue loctite of some kind flywheel cage screws x4 some rubber bands optional- 10-32 thumbscrews for hot swap feature. Crediting Ofp here because thingiverse doesn't have a remix on here. Remix of https://www.thingiverse.com/thing:4313968 https://www.thingiverse.com/thing:4531968 since thingiverse is bork af and won't let me list them as remixes
Statistics
Likes
1
Downloads
0