Nerf Elite 2.0 Phoenix Flywheel Cage
Description
Replacement flywheel cages for the Nerf Elite 2.0 Phoenix, designed to fit in the "coffin" housing the original. You'll need to remove quite a bit of plastic - both for fitting the motors, and for making sure the flywheels have clearance above them. Note that while the wheel wells are large enough for Daybreaks, the mounting posts will interfere with them fitting. Shave down the sides of supports as needed, but at your own risk. In time, I hope to have a motor cover that clips onto the side of the blaster. There are also dual cages, set at 41mm and 40mm. Untested, but there if anyone wants to try them. The Phoenix is solvent-welded, in addition to the few screws. If you're unable to use prying tools to open it, you'll need to slice a few supports as indicated (carefully slide the blade of a saw or rotary tool between shell halves, or cut down the middle). There's also a solvent weld at the front of the orange "coffin", just below the barrel attachment lug.
Statistics
Likes
8
Downloads
0