Ender 3 V2 raised feet, padded for noise & resonance reduction
Description
Looking to reduce noise and resonance from my Ender 3 V2 during printing, and also raise the machine slightly to allow for fitment of baffles/silencers on PSU and maybe later on motherboard fans. The machine sits on an IKEA lack table/enclosure, which already has rubber floor feet, so the annoying vibrations were developing between machine and table. All the machine feet/legs I found on Thingiverse were using loads of material and were probably going to be too rigid. So knocked-up a design with semi-flexible feet that carry 3mm thick felt pads at 40 x 40mm that I already had available (bought from any hardware or furniture store). These feet locate onto the stock Ender rubber pads on the base and lift the machine by ~25mm. Used PETG material for durability. They look great and so far seem to work by reducing all the resonance I was previously getting - could probably benefit further from anti-vibration rubber pads.
Statistics
Likes
20
Downloads
0