Air Venturi Avenger Suppressor
Description
This is a version of my Umarex Gauntlet Suppressor with the thread modified to fit an Avenger. Was told that its M24x1.0. This is designed to replace the barrel end cap and leave the OEM baffles and spring in place. No adapters are required. Prints close enough on my Prusa MK3S with 0.1mm layer height on the threads but you might need to run a M25-1mm tap over it for a better fit. Warning: I don't own an Avenger and haven't tried this personally. If someone prints one, please let me know if it fits ok and how it works. I'm willing to adjust the threads if someone sends me corrections. Added Version 2 which has a thicker neck - it was reported that this broke at the neck when printed with PLA Added a version with the threads reduced by 1mm to accommodate some other 3d printers. Use this if you don't want to buy a M24x1.0 die and the threads are too big to screw in. WARNING: Intended for Airgun Use Only More about my 3d printing setup is here: https://cockrum.net
Statistics
Likes
22
Downloads
0