Raspberry Pi GoPro Case with Screw Holes
Description
A GoPro Compatible Raspberry Pi Camera mount. The back piece is the same as the original and only included for the sake of a complete print, but the front panel is different. The original had these 2MM pegs on them that are both difficult to print, structurally weak, and a tight fit, so I redid the front case to accomodate 4 M2x12mm screws. They thread into the plastic just fine, so no nuts are needed. EDIT: Added a revised version. on my Raspberry Pi Camera v1.3, the front panel was slightly off. I don't know much about the raspberry pi version differences, but if your camera doesn't fit, try the revised file.
Statistics
Likes
2
Downloads
0