BIBO Bed Frame Brace
Description
Updates: Added new versions -- - Thick: thicker, stiffer version - One piece: prints as a single piece without the separate cap. - Easy Install: has a cutout so the bearing screws do not need to be fully removed. With the printer upright, loosen all four screws all the way without removing the nuts. The bracket should slide all the way into place. then retighten the screws. *Use 25% concentric infill for best stiffness* Braces to go under the bed to attempt to help with sagging and vibration on the BIBO 2 touch. The bed bearing mount needs to be unbolted, the mount inserted, and then the bearing mount reinstalled with longer screws (20mm). Don't lose the white plastic spacers that are in the stock mount, they need to stay in. Once installed, the long part of the brace should extend down the inside of the bed frame. Installed on my BIBO, and made a noticeable difference. I had to relevel the front of my bed by about 1mm due to reduced sagging. In the photo of the front of the bed, the brace was installed on the left only. You can see the difference in leveling if you look closely. Hopefully it will continue to help over time.
Statistics
Likes
1
Downloads
0