Carboard Spool Idler Ring for - FormFutura, DSM and Mitsubishi
Description
<h3>RC-1.5 - 26 Januari 2021</h3> Did some minor tweaks to the model, no need to trash the previous one if printed. <h3>RC-1 - 14 November 2020</h3> Do you use FormFutura's, DSM or Mitsubishi Filaments? You know these are all on cardboard spools with a bore (hole) diameter of 56mm. The cardboard spools give a lot of friction and or wears down and leaves super tiny particles of cardboard everywhere, like dust... And it's annoying... Well SAY NO MORE! Print 2 of them and you are eliminating the problem. If it's too tight just press harder, it's not your grandma, it has a very, very snug fit so it won't come off. Rafts: No Supports: No Resolution: 0.2mm Layer Height Infill: 15% Filament_brand: FormFutura Filament_material: PETG
Statistics
Likes
1
Downloads
0