Filament guide/run-out sensor relocation (Creality CR-10S PRO V2)
Description
I have made this Creality CR-10S PRO V2 filament guide after trying different design that were already made by other creators without to much luck. There was always some problems/wear even from my own remix. And I wanted to move to the left the filament run-out sensor so I can more easily push new material into the bowden tube. You will need: 1x 608RS bearing 4x M3 8mm countersunk flat head screws 4x M3 20mm countersunk flat head screws 4x hex nut
Statistics
Likes
4
Downloads
0